[. . . ] Before using this product, read the Xbox™video game system instruction manual for safety, health and other information. Place the clamp screw (15) into the clamp (16) and then screw the clamping unit into the hole on the underside of the wheel until firmly fixed into place. Be careful not to over-tighten the clamp to avoid damaging either the clamp or the table. [. . . ] NASCAR® is a registered trademark of the National Association for Stock Car Auto Racing, Inc. Microsoft®, Xbox™ and the Xbox™ logo are either registered trademarks or trademarks of Microsoft Corporation in the U. All other nationally and internationally recognized trademarks and brand names are hereby acknowledged. Contents, designs and specifications are subject to change without notice and may vary from one country to another. Press the button once: the LED turns green, and then turns off (Sensitivity = low). Press the button again: the LED turns yellow, and then turns off (Sensitivity = high). Press the button once more: the LED turns red, and then turns off (Sensitivity = medium). Press the button once: the LED turns green, and then turns off (Vibration = 0%). Press the button again: the LED turns yellow, and then turns off (Vibration = 50%). Press the button once more: the LED button turns red, and then turns off (Vibration = 100%). BUTTON AND AXIS PROGRAMMING – OVERVIEW • The function of every analog button (A, B, X, Y, Black, White) can be applied to another analog button, D-Pad direction or axis (axes include the brake and gas levers, as well as the left and right directions on the steering wheel). €¢ The function of every axis can be applied to another axis, analog button or D-Pad direction. €¢ If a D-Pad direction is programmed onto an analog button, that analog button then becomes digital. The Start, Back, Program, Vibration and Sensitivity buttons, as well as the brake and gas pedals, cannot be programmed. [. . . ] Next, press the progressive brake lever all the way in: the LED flickers red. The A button now performs the brake lever’s function, and the brake lever retains its original function. To return to the default configuration: Hold down the Program button for more than 3 seconds: the LED will turn red during this time, and will then turn green for 2 seconds. [. . . ]